forsite


  • Mold and mildew-resistant coating based on silver, a natural antifungal.

  • Greatly improves water resistance of wood, wallboard, and gypsum.

  • Exterior-grade, but can be used indoors

  • 10-year warranty on interior wall cavities and structural framing.

  • Does not act as a biocide. Mold and mildew must be removed prior to application.

  • Now available in a convenient aerosol spray can.

Pricing:
Forsite clear / blue

spray
$10.36

gallon
$47.96

5 gallon
$230.36

    click to return to styles and colors

  • overview

    the story

    Foresite is a water-based mold and mildew resistant coating and sealer for new construction, remodeling, decks and patio areas, attics and crawl-spaces, bath and kitchens, mold remediation and water clean-ups. Foresite provides long-term, residual protection against water intrusion, excessive moisture, mold and mildew growth.

    performance

    Forsite effectively prevents mold and mildew and improves water resistance of wood or drywall. Forsite also miinimizes surface water absorption under wet conditions.

    Next: Health
  • health

    at home

    This is a Low-VOC product that helps prevent the growth of mold and mildew in your home. Engineered silver provides an inhospitable environment for mold to grow.

    Next: Use
  • use

    where can i use it?

    • Can be used interior and exterior.(but doesn’t last as long in areas with direct exposure to rain/water.
    • Wood, Oriented Strand Board (OSB), Sheathing.
    • Bare wallboard/sheetrock
    • Concrete, Stucco, Brick, Masonry and tile
    • Many fabrics (awnings, shower curtains)
    • ForSite provides excellent protection for grout lines (e.g.., overtop of an existing grout sealer like AFM’s grout sealer)
    • ForSite can help prevent the growth of mold on decks/railings (apply over existing deck finish)

    how much do i need?

    • With airless sprayer: up to 1600 sf/gal (1000 sf typ at 3 mm thickness)
    • With pump sprayer, brush or roller: 150-450 sf/gal (depending upon surface porosity and how thinly it is applied)
    • With the aerosol can, the coverage rate is: 50sf/can or 533sf/gal (about $0.21/sf)
    • This is a one coat product

    how do i install or apply it?

    • If applying over an already moldy area, remove the mold and mildew before applying the ForSite. Repair any source of water/moisture intrusion before applying ForSite
    • Prep surface: remove all oil, grease, standing water, mold and mildew
    • Mix ForSite thoroughly before and during application
    • Apply in temps between 40-90 degrees F
    • Be sure to apply in a very thin coat
    • Do not over apply ForSite or allow product to puddle on the surface. Excess material should be removed to avoid cracking and peeling of the coating

      • Previous: Health